To Re-Perform Calibration; Performing Calibration After Each Startup - Casio YA-W72M User Manual

8.
With each tap, a calibration mark will appear in the lower left, upper right, and
then lower right corners of the dot screen. Tap the center of each mark once
with the digital pen.
Calibration is complete when you tap the fourth calibration mark.

To re-perform calibration

Perform the procedure under "To perform calibration", starting from step 4. Even while calibration
marks are displayed, you can restart calibration by going back to step 4 under "To perform
calibration".

Performing Calibration after Each Startup

You can configure IWB for CASIO to execute the calibration process whenever the dot screen is
tapped after startup. To do this, perform the steps below.
1 Click the Interactive Whiteboard for CASIO icon (
2 On the menu that appears, select "Perform calibration with each startup" so a check mark appears
next to it.
When this option is selected, the currently configured calibration information is discarded when you
exit IWB for CASIO. You should select this option if you frequently need to move the dot screen and/or
projector between presentations.
If there is no check mark next to "Perform calibration with each startup" (indicating that the option is
disabled, which is the initial default setting), calibration information produced by the last calibration
process is retained in memory. This means that tapping the dot screen will not start the calibration
process after you start up Interactive Whiteboard for CASIO.
Important!
If the projector is not the computer's primary display device, you will need to perform the
procedure under "To perform calibration" (page 28) as required, even if there is not check
mark next to the "Perform calibration with each startup" option.
) in the computer's task tray.
29