11Mbps Wireless Ethernet Adapter User's Manual
The Server Tab
Note!
You may need to reboot the adapter, and then re-load the page to see
any new settings.
The Admin Tab
Note!
You may need to reboot the adapter, and then re-load the page to see
any new settings.
IP Address Mode: Select "Static" or
"DHCP" mode. For "Static" mode,
the IP address settings are given by
user. For "DHCP" mode, IP settings
will be overridden by a DHCP server
on your network. The default setting
is "Static"
IP Address: The static IP address
you may assign to the adapter. The
default value is "169.254.100.100".
IP Subnet: The subnet mask you
want to assign for the adapter. The
default value is "255.255.0.0".
IP Gateway: The gateway you want
to assign for the adapter. The default
value is "169.254.1.254".
Allow upgrade uploads: Check the
box, and then it is allowed to
upgrade firmware.
Change password: Default
password is "1234". For security
concerns, please change it after
finish the configuration.
Reboot Adapter: When any setting
was changed, the adapter MUST be
reboot so that the change can be
confirmed.
Reset to factory defaults: This
option will ERASE all the current
settings, and restore to the factory
default settings.
22