Foxconn P43A Series User Manual page 23

Audio Connector : CD_IN
CD_IN is a Sony standard audio connector, it can be connected
to a CD/DVD-ROM drive through a CD/DVD audio cable.
front Panel Connector : fP1
This motherboard includes one connector for connecting the
front panel switch and LED Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel IDE indicator LED. It
indicates the active status of the hard disks. This 2-pin
connector is directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the switch
is pressed.
Power leD Connector (PWR-leD)
Connect to the power LED indicator on the front panel of
the chassis. The Power LED indicates the system's status.
When the system is in operation (S0 status), the LED is
on. When the system gets into sleep mode (S1) , the LED
is blinking; When the system is in S3/S4 sleep state or
power off mode (S5), the LED is off. This 2-pin connector
is directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of the
chassis. Push this switch allows the system to be turned
on and off rather than using the power supply button.
IrDA Connector : IR
This connector supports infrared wireless transmitting and
receiving device.
1394a Connector : f_1394 (
The 1394a expansion cable can be connected to either the front
(provided that the front panel of your chassis is equipped with
the appropriate interface) or real panel of the chassis.
only available in P43A-S
16
CD_L GND CD_R
1
CD_IN
1
+
HDD-LED
-
RESET-SW
NC
9
FP1
1
+5V
2
EMPTY
3
IRRX
4
5 IRTX
IR
1
)
TPA+
GND
TPB+
+12V
EMPTY
9
F_1394
2
+
PWR-LED
-
PWR-SW
EMPTY
10
GND
2
TPA-
GND
TPB-
+12V
GND
10