North Bridge Configuration - Foxconn P41A-G User Manual

North Bridge Configuration

CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
North Bridge Chipset Configuration
► Video Function Configure
Memory Remap Feature
PCI MMIO Allocation:4GB To 3328MB
DRAM Frequency
Memory Timing by SPD
Memory Hole
Initate Graphic Adapter
IGD Graphics Mode Select
IGD GTT Graphic smemory size [No VT mode, 2MB]
PEG Port
↑↓←→:Move Enter:Select
► Video Function Configure
Press <Enter> to go to its submenu.
► Memory Remap Feature
This item is used to enable/disable memory remap feature. Its mainly for if you have a 64bit
OS and 4GB of RAM. Basically it allows you to remap the overlapped PCI memory above the
total physical memory.
► DRAM Frequency
This item is used to adjust the DRAM frequency. Select [Auto] for SPD enable mode. You also
can select a value manually such as [800 MHz].
► Memory Timing by SPD
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a memory module. It
contains important information about the module's speed, size, addressing mode and various
other parameters, so that the motherboard memory controller (chipset) can better access the
memory device.
► Memory Hole
This item is used to determine whether the 15M-16M address field of memory is reserved for
the ISA expansion card.
► Initate Graphic Adapter
This item is used to choose the initate graphics controller which will be used as the primary
boot device.
► IGD Graphics Mode Select
This item is used to select the amount of system memory used by internal graphics device.
► PEG Port
This item is used to enable/disable PCI Express graphics port.
North Bridge Configuration
[Press Enter] [Press Enter]
[Enabled]
[Auto]
[Enabled]
[Disabled]
[PEG/PCI]
[Enabled, 64MB]
[Auto]
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
29
Help Item
F1:General Help