Rivera Quiana Studio Owner's Manual page 16

Slaving a second Quiana/Fandango
SPEAKER 1
LINE OUT
SPEAKER 2
USE FIRST 560
TOTAL MIN. Z 8 55 W. RMS
SPEAKER JACKS IN PARALLEL
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
TO SPEAKER
CABINET
SPEAKER MUST
BE CONNECTED
Using a shielded cord, connect the first RIVERA's Line Out to the Effects Loop Return
jack on a second RIVERA. Adjusting the Return Level of the second amp sets the
relative volume of the second amp. All tone and distortion adjustments are made by the
first amp. Alternatively, you can use the Effects Loop Send jack from the first amp
instead of its Line Out. The Send Level control sets the signal level being sent to the
second amp. Note: Make sure that at least one speaker cabinet is connected to each
amp at all times.
Slaving a second amp or power amp
SPEAKER 1
SPEAKER 2
USE FIRST
TOTAL MIN. Z 8 55 W. RMS
SPEAKER JACKS IN PARALLEL
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
TO SPEAKER
CABINET
SPEAKER MUST
BE CONNECTED
Connect a shielded cord from your Quiana/Fandango's Line Out to the Power Amp In or
Effects Loop Return of a second amp. All volume and tone changes made on the
Quiana/Fandango will affect what comes out of the second amp. Caution: Never use the
speaker outputs as line outputs. Their power level is extremely high and can cause
tremendous damage to another amp's input. If you don't have any effects patched into
the Quiana/Fandango's Effects Loop, you can use its Send jack instead of the Line Out.
The Send Level knob then acts as a variable output level.
RETURN
LEVEL
RETURN
250K
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL
LINE OUT
560
Quiana and Fandango 1.0 p 16
EFFECTS LOOP
SEND
LEVEL
SEND
Z IN Z OUT
560
POWER AMP
IN