Rivera Quiana Studio Owner's Manual page 14

Driving one external speaker cabinet
SPEAKER 1
SPEAKER 2
USE FIRST
TOTAL MIN. Z 8 55 W. RMS
SPEAKER JACKS IN PARALLEL
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
Using a heavy-gauge speaker cord, connect the output jack labeled Speaker 1 to the
speaker input on an extension cabinet with a minimum of a 4-ohm impedance and
power-handling capacity of at least 60 watts for the Quiana 50/Fandango 55. A single 8-
or 16-ohm extension cabinet can be used, too. For the best tone and maximum output,
we recommend using any of the RIVERA speaker cabinets loaded with either Celestion
Vintage 30's, or our special 10" driver. For the Quiana/Fandango 100, make sure the
combined power rating of the speaker system or enclosure is at least 120 Watts.
Note: Regardless of the type or number of speaker cabinets you use, always make sure
that the Quiana/Fandango's Impedance Selector is set to match the speaker cabinet's
impedance.
Driving internal and one external speaker cabinet
SPEAKER 1
SPEAKER 2
USE FIRST
TOTAL MIN. Z 8 55 W. RMS
SPEAKER JACKS IN PARALLEL
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
TO INTERNAL
SPEAKER
In this configuration, the Quiana is driving the internal speaker load, with an identical
impedance external load. Using heavy-gauge speaker cords, connect the output jack
labeled Speaker 2 to the speaker inputs on extension cabinets with a minimum 8-ohm
impedance and power-handling capacity of 60 watts. Set the Quiana's Impedance
Selector to 4 ohms.
LINE OUT
560
LINE OUT
560
Quiana and Fandango 1.0 p 14
8
8