Peavey AAM 1662 User Manual page 3

To prevent electrical shock or potential fire hazards, do not expose the AAM
Before using this product, read the user manuals for further warnings and cautions.
The following cautions should be carefully observed when installing, wiring or using this product:
DO NOT use any other power supply or cable other than the one provided with this unit.
DO NOT remove the top cover of the unit. There are no user serviceable parts inside. Refer service
to qualified personnel.
DO NOT use solvents or other cleaners to clean the unit. Basic external care requires only a damp
cloth. Disconnect the power supply cord before cleaning.
Read all safety and installation instructions and retain all documentation for further reference.
The AAM 1662 should be installed so that its mounting position does not interfere with proper ven-
tilation.
This product should not be installed or placed near a source of heat.
Power supply cords and associated connectors should be unplugged from the power source when
the unit is not used for long periods of time, or will be stored.
If this product is to be mounted in an equipment rack, install rear support if required by the rack
manufacturer.
Care should be taken to ensure that the installation is clear of possible sources of contamination.
Make sure that the product's ventilation openings are not exposed to possible sources of liquid,
gases, or other contaminants.
This product should be inspected by a qualified service technician if the power supply cord or con-
nector has been damaged, if the unit has been dropped, or if a foreign substance has gained access
to the interior electronic and electrical components.
The information contained in this manual is subject to change without notice. Peavey Electronics is not liable
for improper installation or configuration. The information contained herein is intended only as an aid to
qualified personnel in the design, installation and maintenance of engineered audio systems. The installing
contractor or end user is ultimately responsible for the successful implementation of these systems.
All creative content, including but not limited to, specifications, layout design, artwork, photography, draw-
ings, illustrations and logos are Copyright © 2001 Peavey Electronics Corporation, all rights reserved, except
where noted. The "fast forward", stylized Peavey logo, the "AA Blue Wave" logo and the Architectural
Acoustics brand name are registered trademarks of Peavey Electronics. Un-authorized duplication or distribu-
tion is prohibited by law. This manual was designed, written, formatted, pre-press and printed in Meridian,
Mississippi, USA. 2001.
Manual by WR.
GENERAL CAUTIONS AND WARNINGS!
1662 to moisture or rain.
™