CyberPower RMCARD202 User Manual page 15

CyberPower Remote Management System
Audible Alarm
Dry Relay Function
Screen Saver Time
Wiring Fault Detect
Non-Critical Outlet Bank
Turn Off Threshold
Turn off Delay Time
Turn On Delay Time
enabled, the UPS can be turned on without
input power.
If this option is enabled, the UPS will issue
an audible alarm when supplying battery
power or output overload.
This configures the power condition for the
UPS dry relay to function when the selected
condition occurs. Refer to UPS manual for
further information about advanced UPS dry
relay utilization. The Dry Relay Function
provides following power conditions:
Utility Failure: The utility power fails and the
UPS is using battery power.
Low Battery: The battery capacity is too low
to support the connected computers to
shutdown.
Alarm: The UPS is issuing the audible alarm
due to the occurrence of warning events,
such as overload.
Bypass: The UPS has switched to Bypass
mode due to overload or UPS fault.
UPS Fault: The UPS could be malfunctioned
due to hardware fault, such as inverter fault,
bus fault or overheated.
When no UPS button is pressed or no power
event occurs during this delay, the LCD
screen will be turned off.
If this option is enabled, the UPS will detect if
the UPS wiring is not grounded or is
reversed. It is recommended to assure the
UPS wiring has ground connection first. This
option should be enabled if the UPS wiring
has ground connection.
When supplying battery power, the UPS will
power off the NCL outlet if the remaining
battery capacity is lower than this threshold.
When supplying battery power, the UPS will
power off this NCL outlet after this delay time
is met.
When utility power is restored, the UPS will
restore the output of the NCL outlet after the
delay time is met. This prevents excessive
power consumption caused by all the
connected equipment rebooting at the same
time.
13