Table of Contents
Advertisement
Chapter 2: Using your All-in-One PC
Assembling the base of your All-in-One PC
1.
Place the All-in-One PC on a flat and
stable surface such as a table or desk.
2.
Align and attach the base to the stand.
Ensure that the stand is fitted firmly and
aligned properly to the base.
NOTE: The stand fits to the base in one
orientation only.
3.
Secure the base to the stand with the
bundled screw using a Phillips or a flat
screwdriver. You can also use a coin or
token.
NOTE: The illustration above are for reference only. The actual base of your AiO may vary
depending on the model but the installation steps remains the same.
Positioning your All-in-One PC
1.
Place your All-in-One PC on a flat surface
such as a table or desk.
2.
Tilt the display to an angle between -5
25
.
o
IMPORTANT! Avoid adjusting the display to
an angle beyond the recommended values or
you may risk damaging the All-in-One PC.
All-in-One PC ET232 Series
-5
O
to
o
screw
base
stand
25
O
17
Advertisement
Table of Contents
