Table of Contents
Advertisement
If objects are located both in front of and behind
the vehicle, an alternating continuous signal is
sounded.
The intermittent tone is interrupted after approx.
3 seconds:
▷
If the vehicle stops in front of an object that
is detected by only one of the corner sen‐
sors.
▷
If moving parallel to a wall.
The signal tone is switched off:
▷
When the vehicle moves away from an ob‐
ject by more than approx. 4 in/10 cm.
▷
When transmission position P is engaged.
Volume
You can set the volume of the PDC signal tone,
refer to page 185.
The setting is stored for the remote control cur‐
rently in use.
Visual warning
The approach to an object can be shown on the
Control Display. Objects that are farther away
are displayed on the Control Display before a
signal tone sounds.
The display appears as soon as PDC is acti‐
vated.
If the last image selected was the rear view cam‐
era, this is displayed again. To switch to PDC:
"Switch off rear view camera"
The setting is stored for the remote control cur‐
rently in use.
Online Edition for Part no. 01 40 2 901 869 - 03 12 500
Driving comfort
Image on the Control Display
Switching on the rear view camera
using iDrive
With PDC activated:
"Rear view camera"
The image of the rear view camera is displayed.
The setting is stored for the remote control cur‐
rently in use.
Malfunction
A Check Control message, refer to page 83, is
displayed in the instrument cluster.
The areas in front of and behind the vehicle ap‐
pear in shaded form on the Control Display. PDC
has failed. Have the system checked.
To ensure full operability:
▷
Keep the sensors clean and free of ice.
▷
When using high-pressure washers, do not
spray the sensors for long periods and main‐
tain a distance of at least 12 in/30 cm.
Surround View
The concept
Surround View encompasses the following sys‐
tems:
▷
Backup camera, refer to page 120.
▷
Top View, refer to page 122.
▷
Side View, refer to page 124.
Controls
119
Advertisement
Table of Contents
