Troubleshooting - Nikon F100 Instruction Manual

Troubleshooting

LCD panel Viewfinder
ƒEE blinks
M appears
M blinks
M and Err
blink
ƒ-- appears
Err and E blink
a, s, and
Err blink
E blinks when
exposure meter exposure meter
is turned on
End blinks
—
ƒEE blinks
• CPU Nikkor lens (other
than G-type) is not set
to its minimum
aperture.
• Batteries are nearing
—
exhaustion.
• Batteries are just about
—
exhausted.
Err blinks
• Batteries are
exhausted during film
rewind.
ƒ-- appears
• Non-CPU lens is
attached or lens is not
attached.
Err and
• Film is not correctly
E blink
advanced.
Err blinks
• Film speed is set to DX
and non-DX-coded film
is loaded.
E blinks when
• Film remains in the
camera after film
rewind is complete.
is turned on
End blinks
• The end of the film roll
has been reached.
? blinks
• Autofocus is not
possible.
Cause
• Set lens to minimum
aperture.
• Have fresh ones ready.
• Turn the power off and
replace batteries with
new ones.
• Replace batteries with
new ones or recharge
batteries and turn the
power on again. If this
warning appears
frequently, contact
authorized Nikon dealer
or service center.
• Attach CPU lens (except
IX/DX-Nikkor). With a
non-CPU lens, set the
exposure mode to A or
M and set the aperture
with lens' aperture ring.
• Reload film.
• Load DX-coded film or
set the film speed
manually.
• Remove the film
cartridge.
• Rewind film by
pressing the two film
rewind buttons „.
• Focus manually.
Remedy Page
18, 32
21, 34
18
17
17
17
21
29
29
27
99