Download  Print this page

Honeywell RDD100 User Manual

Remote digital display
Hide thumbs

Advertisement

Quick Links

Honeywell Pressure Sensor Products
RDD100 Remote Digital
Display User Manual

Advertisement

loading

  Related Manuals for Honeywell RDD100

  Summary of Contents for Honeywell RDD100

  • Page 1 Honeywell Pressure Sensor Products RDD100 Remote Digital Display User Manual...
  • Page 2: Table Of Contents

    RDD100 User Guide Table of Contents Introduction Product Overview Transducer Description Equipment Set Up Cables & Connections Personal Computer Set Up Set Transducer Baud Rate Setting Transducer Display Units “Continuous Transmit” Mode Changes Stored In EEPROM Verifying Stored Parameters Operation...
  • Page 3: Introduction

    (two-way communications). The RDD100 is housed in a compact enclosure, measuring approximately 3.8 x 2 x 4.4 inches, W x H x D. The instrument may be used on a tabletop or can be easily installed in a panel using the supplied mounting hardware.
  • Page 4: Set Transducer Baud Rate

    Set Transducer Baud Rate When a Honeywell digital transducer, connected to a computer as described above, is first powered up a start-up message will be sent from the transducer. If the transducer baud rate is not set at 9600, either no message or a garbled message will be received.
  • Page 5: Continuous Transmit" Mode

    User’s Manuals. Note: Since pressure units are not a part of the RDD100 display, the user may want to attach a sticker or some other indication of the pressure units either on or near the display window.
  • Page 6: Operation

    Start Up Messages When the RDD100 is powered up, it goes through a test of its display segments and its error LED. The error LED is located beneath the least significant digit of the display. All segments should light for a brief period and then the display transitions to “rdd100”, “Sr 2.0”, and “rEAdY”.
  • Page 7: Power Requirements

    Sequence #3: If both RDD100 and transducer are operating normally before an over/under-range condition is detected, the RDD100 will continue to display the valid last reading prior to the error condition. The error LED will not be lit. POWER REQUIREMENTS Voltage 12 ±...
  • Page 8 RDD100 User Guide Honeywell International 12001 State Highway 55 Plymouth, MN 55441 ADS-14124 Tel: 1-800-323-8295 December 2012 www.honeywellmps.com www.honeywell.com...