Advertisement
OPERATING INSTRUCTIONS (CONT.)
SELECTING IRON
TEMPERATURES
Always read garment labels and follow
the manufacturer's ironing instructions.
Refer to the "Ironing Chart" on page 12
for temperature recommendations:
•
Use low settings for synthetics.
•• Use moderate settings for wool,
silks, and blends.
••• Use high settings for cottons and
linens.
ATTACHING THE IRON TO
THE IRONING BOARD
Your iron is equipped with a clamp that
can be used to attach the iron stand to
your ironing board (or any other stable,
protected surface).
1. Rotate the clamp 90º so that it points
downward.
2. Place the iron stand next to the edge
of the ironing board with the clamp
on the bottom. See Figure 5.
3 Turn the wing nut clockwise to
tighten clamp to the ironing board.
4. Turn nut counterclockwise to loosen
clamp and remove iron stand from
ironing board.
Figure 5
IRONING HINTS
WARNING!
To prevent fire, do not
leave iron unattended while
connected.
•
Sort articles to be ironed according
to the type of fabric. This will reduce
the need to adjust the temperature
for different types of garments.
•
If you are not sure of the fiber
content of a garment, test a small
area such as a seam or inside hem
section before ironing a visible area.
Start with a low temperature setting
and gradually increase to find the
best setting.
•
When reducing the temperature to
iron sensitive fabrics, allow
approximately 2 minutes for the iron
to cool to the new temperature
setting.
•
Fabrics such as velour, wool, linen
and silk are best ironed with an
ironing cloth to prevent shine marks.
9
CARACTERÍSTICAS DE LA PLANCHA KENMORE
ALÁMBRICA / INALÁMBRICA (
Uso alámbrico
("Corded")
7. USO ALÁMBRICO
Coloque el interruptor de tres
posiciones en el modo "corded"
para usar la plancha con el módulo
que contiene el cordón.
Posición fija
("Locked")
8. POSICIÓN FIJA
Coloque el interruptor de tres
posiciones en el modo "locked"
para que la plancha y el módulo del
cordón queden fijos en el soporte
para guardar o transportar la plancha.
continuación)
Uso inalámbricp
("Cordless")
9. USO INALÁMBRICO
Coloque el interruptor de tres
posiciones en el modo "cordless"
y retire la plancha del soporte,
dejando el módulo del cordón
unido al soporte.
22
Advertisement
