Page 1
Subwoofer Owner’s Manual: SubCompact 6, SubCompact 8, SubCompact SubSonic , Baby Boomer , S-Fit Cnr Sub 300 , CS 66 , CS 88 Baby Boomer Plus , Sonic 500 Digital Sub 600, SuperSonic & UltraSonic 2008 PINNACLE LOUDSPEAKERS...
Page 3
® We congratulate and thank you for choosing a PINNACLE subwoofer. Our subwoofers exemplify the best in modern audio technology, and are designed to produce tremendous amounts of deep bass. Please read this manual completely to ensure the best possible performance from your Home Theater or sound system.
Page 4
at least 2-3 feet away from your subwoofer to prevent damaging them. CONNECTIONS: Complete all wire connections in your Home Theater/Sound system before powering up your subwoofer or your receiver (amplifier). Be sure to observe proper polarity for all speaker wire connections (+ to +, - to -).
Page 5
Simply connect your subwoofer, using either the L or R Line Input jack, to the subwoofer output jack on your receiver. If you have a Dolby Digital (AC-3) or DTS receiver or processor place the subwoofer's Crossover Bypass switch in the ON position (this bypasses the Low Pass Filter in the subwoofer). If you do not have a Dolby Digital (AC-3) or DTS receiver or processor place the subwoofer's Crossover Bypass switch in the OFF position (this activates the Low Pass Filter in the subwoofer).
Page 6
There are two reasons to use this connection option. The first is if your receiver has no RCA subwoofer output jack! The second is if your system would benefit from having the bass filtered out of the main speakers. (If you have a Dolby Digital or DTS receiver you can achieve the same results electronically simply by configuring your main speakers as SMALL and connecting your sub via a Phono cable - See Option #1).
Adjust the PHASE switch on the subwoofer’s control panel to determine which position sounds the most natural. The difference should be most audible in the mid-bass. If you cannot detect a difference, leave the PHASE switch in the 0° (in-phase) position. If you have placed your subwoofer's Crossover Bypass switch in the OFF position adjust the FREQUENCY ADJUST knob and determine what position sounds best.
With high volume levels of certain types of signals, the subwoofer may be audibly strained. If you hear the subwoofer “breaking-up” or distorting, turn your receiver’s volume level down. ® If you have any problems or questions please contact your PINNACLE dealer for further assistance. TROUBLESHOOTING: No Sound only from Subwoofer - Please note that this subwoofer has a thermal protection feature which will shut off its amplifier if it gets too hot;...
Parts replacement and labor will be performed at the discretion of Pinnacle Loudspeakers and will be provided free of charge unless (in the opinion of our service department, service representatives, or engineering department) the system has failed due to abuse or negligent operation.
Page 12
1 Fairchild Court Suite 140 Plainview, NY 11803 Tel. (516) 576 9052, Fax. (516) 576 0826 pinnacle@pinnaclespeakers.com http://www.pinnaclespeakers.com PR MAN QB REV0508...