Sonar Settings (Hds-5 &7); Network Sonar - Lowrance HDS-5 Operation Manual

Settings
Sonar Settings (HDS-5 &7)
The Sonar Settings Menu is used to modify Sonar
options and display settings like Sonar Source,
Noise Rejection and Fishing Mode.
To access the Sonar Settings:
1. Press MenU twice.
2. Select Sonar and press enTeR.

Network Sonar

Allows your unit to send/receive sonar data from another sonar unit on an ethernet
network. To turn on/off network sonar, highlight Network sonar on the Sonar
Settings menu and press enTeR. Sonar sharing is covered in the Sonar section.
noise Rejection
Interference from bilge pumps, engine vibration,
air bubbles, etc, can clutter your unit's display.
Noise Rejection uses ASP (Advanced Signal
Processing) to automatically clear interference
from the display.
To adjust Noise Rejection:
1. Highlight Noise Rejection on the Sonar Settings menu and press
enTeR.
2. Use the keypad to select the desired option and press enTeR.
Surface Clarity
Wave action, boat wakes and temperature
inversion are some of the sources that can
cause onscreen clutter near the surface.
Surface Clarity reduces surface clutter by
decreasing the sensitivity of the receiver
near the surface.
Sonar Settings Menu
Surface Clutter
78