Advertisement
No picture or sound
Check the power on/off switches on the Transmitter, Receiver and TV
a)
b) Make sure the power plug and signal cables are pushed all the way in.
c) Check if the channel of transmitter & receiver are set to the same channel.
d) Make sure that all cables are connected as per the user guide
e) Check if there is any discontinuity inside the cable.
f) If you use S-Video connection, your TV set must be set to "S-Video" mode
Interference & noise
a) Adjust receiver antenna direction for optimal performance. (see Pictures 5, 6)
b) Adjust transmitter antenna direction for optimal performance. (see Pictures 5, 6 )
c) Check if the supplied voltage matches the adapter specification
( With 230 VAC adapter the input voltage can not be less than 220 VAC)
(The power output has to be 9 VDC, 300mA centre positive)
d) Select a different microwave channel by pushing the channel button on both
transmitter and receiver. (see Pictures 4 ) Make sure channel of transmitter &
receiver are set to the same channel, if they are try using alternative (same on both
units) channels until clearer reception is found.
e) You can also vary the transmitter / receiver position for optimal performance.
f) If the distance between receiver and transmitter is less than 10 M do not open
the antenna as the signal could be too strong to obtain a sharp picture.
g) If using a microwave oven, turn it off.
h) Remove microwave oven or clear unnecessary obstructions from the path
between transmitter and receiver.
TROUBLE SHOOTING
For any further assistance, please contact:
6
Advertisement
