Bosch NurseCall Main Unit User Manual page 12

12 en | Description
Keys Programming Mode
Access to parameters programming.
See Section 4.3 Parameters, page 25.
Access to transmitters programming.
See Section 4.5 Transmitters, page 38.
Scroll up to the next parameter.
Scroll down to the next parameter.
Set a parameter value to OFF or to go to the
previous programming field.
Set a parameter value to ON or to go to the next
programming field.
Confirm a value or a command.
Cancel an entry or a command.
Quit the programming mode.
Check the value of a parameter or a transmitter.
Not used.
NPS programming function. See
Section 4.1.2 Programming with the NPS software,
page 22.
Enter a value.
to
Erase all programmed acknowledgement
transmitters during a specific procedure.
See Section 4.5.8 Erasing all acknowledgement
transmitters, page 42.
Disable the beep codes and delete the POS
indication.
See Section 4.3.5 RS-232 output setting, page 27
and Section Example of programming, Page 28.
Enter a value or to set the default values.
See Section 4.3.5 RS-232 output setting, page 27.
No effect.
then
F.01U.252.699 | V1.1 | 2012.01
Normal Operation
Not used.
Not used.
Increase the volume of the loudspeaker.
See Section 5.1 Adjusting the loudspeaker
volume, page 43.
Decrease the volume of the loudspeaker.
See Section 5.1 Adjusting the loudspeaker
volume, page 43.
Scroll down to the previous alarm/event.
Scroll up to the next alarm/event.
Not used.
Not used.
Check the status of the backup battery.
See Section 7.3 Monitoring the backup
battery, page 47.
Not used.
Not used.
Not used.
Not used.
Not used.
Launch the event/alarm display mode.
Lock and unlock the keyboard.
User Manual
NurseCall Main Unit
Bosch Security Systems