Moog MIDI MuRF MF-105M Usage Instructions page 18

MIX: CC8. When the MF-105M receives a CC8 message on the MIDI
channel that is assigned, the value of the CC8 message overrides the
setting of the front panel MIX control and any steady voltage at the
MIX control input. Moving the front panel MIX control or modifying a
voltage at the MIX control input restores this parameter to its front panel
state.
RATE: CC9 – When the MF-105M receives a CC9 message on the
MIDI channel that is assigned, the value of the CC9 message overrides
the front panel RATE control and any steady voltage present at the
RATE input. Note that w/no MIDI Clock messages being received, this
is a continuous control the same range as the front panel control. When
synced to MIDI, this CC becomes a Clock divider – with 16 possible
settings. (See Clock Divider chart in the MIDI Clock section below).
Moving the front panel RATE control or modifying a voltage at the
RATE control input restores this parameter to its front panel state.
STACCATO MODE: CC68 OFF/ON (0-63 = OFF, 64-127 = ON). This
mode changes the way envelopes behave in "Triggered Mode" (See
below on p. 21 for Triggered Mode description) If this is OFF (which
is the default), then the envelopes go all the way through their attack
and decay no matter how briefly you hold the MIDI note. If "staccato
mode" is ON, then the envelopes play all the way out if you hold down
the MIDI note, but if you release the MIDI note the envelope goes
immediately to zero. This is good for quick, sharp little notes or for using
a sequencer to control articulation.
ENVELOPE SCALE: CC70: CC70 expands/compresses the overall
duration of the envelope while keeping the same shape set by the
ENVELOPE control or CC1. When NOT synced to MIDI Clock, as you
adjust the Rate knob the envelope duration is automatically compressed
at higher Rates and expanded at lower rates, to preserve a musical
envelope response as your sequence changes speed. When Synced
to MIDI Clock, the Rate knob becomes a MIDI clock divider and no
longer affects the envelope scale itself. Using CC70 you can control the
envelope time scale independently of the Rate control.
LFO ON/OFF: CC85; Values: 0-63=OFF; 64-127=ON. When the MF-
105M receives a CC85 message on the MIDI channel that is assigned,
the value of the CC85 message overrides the setting of the front panel
LFO switch if it is in the range of values that is opposite the current
page 18