Door Panel - GE Monogram ZIBI240 Owner's Manual

Product The bar refrigerator with icemaker is factory
set for a 110° door swing.
clearances
When installed in a corner:
Check the model number and allow the
appropriate clearance for the 90° door swing
and to allow racks to slide out.
• ZIBS240 – 4" minimum to wall.
• ZIBI240 – 4-1/2" minimum to wall.
Check the model number and allow the
appropriate clearance for the 110° door
swing.
• ZIBS240 – 14" minimum to wall.
• ZIBI240 – 16" minimum to wall.
NOTE: Clearances are based on the
recommended 2-1/4" handle standoff
depth. Custom handle clearances may vary
depending on the standoff of the custom
handle.
Choose the location:
• These products may be closed in on the
Installing
3/4" Overlay Panel Dimensions
custom 3/4 "
Model ZIBI240 requires a field-installed

door panel

overlay door panel.
and handle
• The overlay panel must be secured to a
(ZIBI240 model
only)
• A custom handle of your choice, supplied
NOTE: Maximum total weight for custom
door panel is 25 pounds.
14
top and three sides as long as the front is
unobstructed for air circulation and
proper access to the door.
1/4" thick backer panel that slides into the
trim. A .10" thick spacer panel must be
placed between the overlay and backer
panel.
by your cabinet maker, must be installed
on this overlay panel. Countersink all
screws into the backer panel. Screws
cannot protrude from the backer panel.
3/4" Overlay Panel Dimensions (in inches)
A (Width)
B
1/4" Backer 23-3/16"
0.10" Spacer 22-1/2"
3/4" Overlay 23-5/8"
Built-In Dimensions/Installation
14" Minimum
(with Custom Panel
110° Door Swing
110°
• Do not install these products where the
temperature will go below 55°F (13°C)
or above 90°F (32°C).
• Do not install where it will be subject to
direct sunlight, heat or moisture.
Black or Stainless Steel Toekick Options
Your custom panel (ZIBI240 model only) bar
refrigerator with icemaker is shipped with
two toekicks, a stainless steel and a black
toekick. For shipping purposes, one of the
toekicks will be secured to the back or inside
of the unit, and the second will be installed
on the unit. Keep the unused toekick and
other unused or removed parts for possible
future use.
B (Height)
29-9/16"
29-1/16"
30"
Bar Refrigerator with Icemaker
to Wall
90° Door Swing
16" Min.)
90°
4" Minimum
(with Custom Panel
4-1/2" Min.)
Overlay
Panel
Door
1/4"
.10 Inch
Backer
Spacer
Panel
21-5/8"
23-5/8"
to Wall