Table of Contents
Advertisement
2
1. Remove the plug from
the power socket.
2. Remove the top hinge
cover.
3. Unscrew the 2 retaining
screws, and remove the
hinge from the appliance.
4. Take the door off.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out the above men-
tioned operations, contact the nearest After Sales Serv-
ice Force. The After Sales Service specialist will carry
out the reversibility of the doors at your cost.
Electrical Connection
Caution! Any electrical work required to install
this appliance should be carried out by a qualified
electrician or competent person.
Warning! This appliance must be earthed.
The manufacturer declines any liability should
these safety measures not be observed.
1
5. Remove the screw fix-
ing the lower door hinge
and the other screw fixing
the lower door hinge and
the foot. Then remove the
door hinge and the foot as
shown in the Figure.
6. Loosen the screw fixing
the foot opposite the lower
door hinge in order to re-
move the foot.
7. Fix the door hinge and
the corresponding foot on
the opposite side and then
the other loosened foot at
the former place of the
door hinge as shown in
the Figure.
8. Please make sure to
place the lower foot below
the door hinge. The lower
foot is recognizable by its
4 ribs on the outer surface.
9. Fix the door onto the
lower hinge pin.
10. To fit top door hinge,
remove the plastic blank-
ing plugs carefully, and re-
fit them in the holes left by
the hinge retaining screws.
1
Important! The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow:
1
Brown:
3
11. Refit the top hinge us-
ing the 2 retaining screws,
taking care that the edge
of the door is parallel with
side of the cabinet.
12. Replace the hinge cov-
er.
13. Relocate the handle
and the plastic plugs to
the opposite side.
14. Level the appliance,
wait for at least four hours
and then connect it to the
power socket.
2
3
4
5
Earth
Live
7
Advertisement
Table of Contents
