Table of Contents
Advertisement
turnInG the APPlIAnCe on
Please note:
Before turning the appliance on, make sure the
main switch on the back of the appliance is in the
I position (fig. 1).
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which can-
not be interrupted.
The appliance is ready for use only after comple-
tion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of
the coffee spouts and is collected in the drip tray
underneath.
Avoid contact with splashes of water.
• To turn the appliance on, press the
button (fig. 5). The message "Heating
up... Please wait" is displayed.
After heating, the message "Rinsing..." is displa-
yed. As well as heating the boiler, the appliance
also heats the internal circuits by circulating hot
water.
The appliance is at temperature when a message
indicating the coffee taste and quantity is displa-
yed.
turnInG the APPlIAnCe oFF
Each time the appliance is turned off, it performs
an automatic rinse cycle which cannot be inter-
rupted.
Danger of burns!
During rinsing, a little hot water flows from the
coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the
(fig. 5). The appliance performs a rinse cycle,
then the message "Turning Off Please Wait..." is
displayed and the appliance goes off.
Please note:
If the appliance is not used for an extended pe-
riod, also place the main switch in the 0 position
(fig. 6).
Important!
To avoid damaging the appliance, never place the
main switch (fig. 6) in the 0 position while the
appliance is on.
menu settInGs
When you access the programming menu by pressing
the P button, the following menu items are available:
Descale, Adjust time, Auto-off, Auto-start, Set tempe-
rature, Energy Saving, Water hardness, Set language,
Install filter, Replace filter, Beep, Default values, Stati-
stics.
descale
For instructions on descaling, see page 16.
Adjust time
To adjust the time on the display, proceed as fol-
lows:
1. Press the P button to enter the menu;
2. Turn the selection knob (fig. 8) until "ADJUST
TIME" is displayed;
3. Press the
4. Turn the selection knob (fig. 8) to change the
hours;
5. Press the
6. Turn the selection knob (fig. 8) to change the
minutes;
7. Press the
This sets the time. Press the
the menu.
Auto-off (stand by)
The appliance is set to turn off automatically if
not used for 2 hours.
The time can be changed so that the appliance
switches off after 15 or 30 minutes, or after 1,
2 or 3 hours.
1. Press the P button to enter the menu;
2. Turn the selection knob (fig. 8) until "Auto-
Off" is displayed;
button
3. Press the
4. Turn the selection knob (fig. 8) until the de-
sired operation time is displayed (15 or 30
minutes, or 1, 2 or 3 hours);
5. Press the
6. Press the
Auto-off is programmed.
Please note:
To disconnect the appliance completely, place
the main switch at the back of the appliance in
the 0 position (fig. 6).
10
button (fig. 2);
button to confirm;
button to confirm.
button to exit
button;
button to confirm;
button to exit the menu.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
