Table of Contents
Advertisement
Behind refrigerator
Care should be taken in moving your refrigerator away from the wall. All
types of floor coverings can be damaged, particularly cushioned coverings
make sure you don't roll over the power cord.
Defrost Water Pan
Defrost water pan
Pan located on top of compressor at
rear of refrigerator should be cleaned
at least once a year. DO NOT
REMOVE PAN. Move refrigerator
out from wall as far as necessary, and
unplug power cord from wall outlet
before cleaning pan. Use a clean
cloth or sponge dampened in warm
water and baking soda solution-one
tablespoon of baking soda to a quart
of water. Do not use cleansing
powders, abrasive cleaners, bleach or
cleaners containing chlorides.
Refrigerator Location
Do not install refrigerator where temperature will
be below 60°F. because it will not run often enough
to maintain proper temperatures.
Do install it on a floor strong enough to support a
fully loaded refrigerator.
Also see Energy-Saving Tips regarding location.
Leveling Legs
Adjustable legs at the front corners of the refrigerator should be set so the
refrigerator is firmly positioned on floor and the front is raised just enough
that the door closes easily when opened about halfway.
To adjust leveling legs, turn legs clockwise to raise refrigerator,
counterclockwise to lower it.
When adjusting leveling legs for proper door closure, the bottom front edge
of the cabinet should be approximately 5/8" from the floor.
Light bulb replacement
The light bulb and socket are
located in the upper right rear
corner of the fresh food
compartment.
To replace the light bulb, unplug
the refrigerator's power cord plug
from the wall outlet. Press the
flexible wire bulb guard until hook
on guard comes out of retaining
hole.
PREPARATION
Clearances
Allow the following clearances for ease of
installation and proper air circulation.
Sides . . . . . . . . . . . . . . . . . . . . . 5/8"
Top . . . . . . . . . . . . . . . . . . . . . . . . . . . 2"
Back . . . . . . . . . . . . . . . . . . . . . . . . 1"
' 1
Hook
Unscrew burned-out bulb and
replace it with a standard 40-watt
appliance bulb. Then push bulb
guard up and press in until it hooks
into the retaining hole.
)
7
Advertisement
Table of Contents
