Husqvarna HU775BBC Operator's Manual page 7

DRIVE CONTROL (See Fig. 6)
• Self-propelling is controlled by pulling either drive control
lever rearward to the handle. The further toward the
handle a lever is pulled, the faster the unit will travel.
• To stop forward motion without stop ping blade, re lease
a drive control lever.
NOTE: If after releasing the drive control the mower will
not roll backwards, push the mower forward slightly to
disengage drive wheels.
OPERATOR
PRESENCE
CONTROL BAR
TO ENGAGE DRIVE CONTROL
DRIVE CONTROL DISENGAGED
OPERATION
DRIVE
CONTROL
LEVERS
FIG. 6
DRIVE CONTROL ADJUSTMENT (See Fig. 7)
Over time, the drive control system may become "loose",
resulting in decreased speed. There is a turnbuckle on
the drive control housing to increase tension on the drive
cable. Pro ceed as follows:
1. Turn unit off and disconnect spark plug wire from spark
plug.
2. Rotate turnbuckle on drive control to increase drive
speed.
3. Operate mower to test drive speed. Readjust as re-
quired.
4. If condition fails to improve after the above steps (for-
ward speed remains the same), your drive belt is worn
and should be re placed.
ADJUSTMENT TURNBUCKLE
TO ADJUST CUTTING HEIGHT (See Fig. 8)
All four wheels are adjusted by a single lever.
• Pull adjuster lever toward wheel. To raise mower, move
lever forward to desired position. To lower mow er, move
the lever toward the rear.
WHEEL
AD JUST ER
LEVER
LEVER BACKWARD
TO LOWER MOWER
LEVER FORWARD
TO RAISE MOWER
7
FIG. 7
FIG. 8