Enhancing Your System - Pioneer X-HM70DAB-K Operating Instructions Manual

General control
Muting
The volume is muted temporarily when pressing the MUTE
button on the remote control. Press again to restore the
volume.
P.bass control
When the power is first turned on, the unit will enter the
P.bass mode which emphasises the bass frequencies. To
cancel the P.bass mode, press the P.BASS button on the
remote control.
Bass control
Press the BASS button, then press / to adjust the bass.
Treble control
Press the TREBLE button, then press / to adjust the
treble.
Equaliser
When the SOUND button is pressed, the current mode
setting will be displayed. To change to a different mode, press
the SOUND button repeatedly until the desired sound mode
appears.
No equalization.
FLAT Equaliser off.
For rock music.
GAME For game.
For classical music.
CLASSIC For classical music.
For pop music. For pop music.
POPS
Vocals are enhanced.
VOCAL Vocals are enhanced.
For jazz.
JAZZ For jazz.
Input function
When the INPUT button on main unit is pressed, the current
function will change to different mode. Press the INPUT
button repeatedly to select desired function.
12
En
CD FM Stereo DAB
NETWORK
AUDIO IN LINE
Note
• The backup function will protect the memorised function
mode should there be a power failure or the AC power
lead becomes disconnected.

Enhancing your system

The connection lead is not included. Purchase a
commercially available lead as shown below.
TIMER
USB
PHONES AUDIO IN 5 V 2.1 A
USB
PHONES AUDIO IN 2.1 A
5 V
Portable audio player, etc.
Audio cable (not supplied)
Listening to the playback sounds of portable
USB
audio player, etc.
1 Use a connection lead to connect the portable audio
player etc. to the AUDIO IN socket.
iPod
2 Press the STANDBY/ON button to turn the power on.
3 Press the AUDIO IN button on the remote control or
INPUT button repeatedly on main unit to select AUDIO
IN function.
4 Play the connected equipment.
• If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the
volume of the connected device. If volume level is too low,
increase the volume of the connected device.
Note
• To prevent noise interference, place the unit away from
VOLUME
the television.
• When using video equipment, connect the audio output
to this unit and the video output to a television.
Headphones
• Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing loss.
• Before plugging in or unplugging the headphone, reduce
the volume.
• Be sure your headphone has a 3.5 mm diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
• Plugging in the headphone disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.