Advertisement
PSH25MGW
GEProfile
Counter-Depth
™
Rough-In Dimensions and Installation Information (in inches)
Collar Trim Installation
Anenclosureisrequiredtomatchuptothe
trim,seeTypicalInstallation.Toobtainthe
mostintegratedlook,thecabinetorsoffit
abovetherefrigeratorshouldextendout
tothesamedepthasthesidepanels.The
refrigeratoropeningmusthaveminimum
dimensionsof70-1/4"highx36-1/8"wide
x24-1/2"deepasshownatright.Ifthereis
anoverheadcabinet,allow1"forcabinet
doorclearancewiththetoptrimpieceso
thecabinetdoorscanbeopenedwithout
hittingthetoptrim.If1/2"sidepanelsare
used,thensidetrimandpanelwillbeeven.
If3/4"sidepanelsareused,thensomeof
thesidepanelwillextendbeyondthetrim
andmustbefinished.
IMPORTANT:Beforefinalizingspecifications
foryourGEProfileCounter-Depth
Refrigerator,pleaseNOTE:
• A minimumof36-1/8"isrequiredfor
refrigeratorinstallationwithcollar
• B esuretoallowfor1/2"or3/4"side
panelsinadditiontothe36-1/8"
minimum.
ForanswerstoyourMonogram,
GEProfile
®
GE
®
appliancequestions,visitourwebsiteat
ge.comorcallGEAnswerCenter
service,
®
800.626.2000.
ENERGYSTAR
24.6Cu.Ft.Side-By-SideRefrigerator
®
Typical Installation
Shadedareasrepresentfrontsurfacesofsidepanelsand
overheadcabinetorsoffitthatcontactstrim.
3/4" Cabinet
Refrigerator
Side Panel
Case
1/2" Cabinet
Side Panel
Magnetic
Tape
Refer collar trim install
Door Gasket
Side Trim
Side trim must be installed
flush with the gasket contact
surface on the case.
or
™
Cabinet
Overhead
Door
Cabinet
1"
*The rough-in dimension of 70-1/4" is minimum and is measured from the
Case
finished floor to top of opening (or the underside of the overhead cabinets).
For Models with Trim Kit: If frameless style cabinets are planned for above the
Top Trim
refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to
height of opening to allow additional clearance between cabinet doors and
top of refrigerator trim when cabinet doors are in open position.
Collar Trim Installation Art
1/2" minimum
70-1/4"*
24-1/2"*
36-1/8"
Listed by
Underwriters
Laboratories
Specification Revised 7/07
210251
Advertisement
