To Reset This Player; On-Screen Error Messages - Sharp BD-AMS10A Operation Manual

Blu-ray disc/dvd player

Table of Contents

Troubleshooting

To Reset this Player

• If this player receives strong interference from a source such as excessive static electricity, strong external noise, malfunction of power supply, or

voltage caused by lightning during use or a wrong operation is sent to the player, errors like the player not accepting an operation may occur.

Press and hold a/; on the player until "

power has been turned off. Then, after the a/; (On/Standby) indicator is lit, turn on the power.

• When a reset is performed while the power is on, the player will turn off. Turn the power on again. At this point, it may take a few moments for the system processing to finish before

the player is ready for use. During the system processing, the BD/DVD/CD mode indicator on the front panel display of the player will blink. Once the system processing has finished,

the indicator will finish blinking and then light up normally. You can operate the player when the BD/DVD/CD mode indicator is lit.

• Since all settings including the language setting stored in memory are also reset when a reset has been performed, they must be set again.

• When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this does not solve the problem, contact the nearest service centre approved by

SHARP.

On-screen Error Messages

The following messages appear on the TV screen in case of an error during operation.

Error message

Cannot play.

Incompatible disc.

Cannot operate.

This USB memory is not formatted properly. Please format

the memory in USB memory management.

The Connected USB Memory cannot be used. It should be

compliant with USB 2.0

NOTE

Cinavia Notice

• This product uses Cinavia technology to limit the use of unauthorised copies of some commercially-produced film and videos and their soundtracks. When a prohibited use of an

unauthorised copy is detected, a message will be displayed and playback or copying will be interrupted.

• More information about Cinavia technology is provided at the Cinavia Online Consumer Information Centre at http://www.cinavia.com. To request additional information about Cinavia

by mail, send a postcard with your mailing address to: Cinavia Consumer Information Centre, P.O. Box 86851, San Diego, CA, 92138, USA.

" appears on the front panel display when the player does not operate properly even after the

Possible Error

• The disc cannot be played back with this player.

• If you load a disc which cannot be played with this

player (i.e. a scratched disc), or if you load a disc upside

down, this message will appear, and the disc tray will

automatically pop out.

• Occurs if the loaded disc cannot be played because it is

a non-standard disc or scratched, etc.

• Occurs if an operation is incorrect.

• Occurs if there is a formatting error.