Table of Contents
Advertisement
Troubleshooting
Network (Continued)
Problem
Cannot download BD-LIVE contents.
Other
Problem
The TV operates incorrectly.
The Player heats up during use.
B (Standby/On) indicator will
remain lit.
To Reset this Player
•
If this Player receives strong interference from a source such as excessive static electricity, strong external noise, malfunction
of power supply, or voltage caused by lightning during use or a wrong operation is sent to the Player, errors like the Player not
accepting an operation may occur. Press and hold B on the Player until "
the Player does not operate properly even after the power has been turned off. Then, after the B (Standby/On) indicator is lit,
turn on the power.
•
When a reset is performed while the power is on, the Player will turn off. Turn the power on again. At this point, it may take
a few moments for the system processing to finish before the Player is ready for use. During the system processing, the
BD/DVD/CD mode indicator on the front panel display of the Player will blink. Once the system processing has finished, the
indicator will finish blinking and then light up normally. You can operate the Player when the BD/DVD/CD mode indicator is lit.
•
Since all settings including the language setting stored in memory are also reset when a reset has been performed, they must
be set again.
•
When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this does not solve the
problem, contact the nearest service centre approved by SHARP.
48
•
Is the LAN cable connected properly?
•
Is the USB memory device properly connected? Check that the USB memory
device is connected to the BD STORAGE/SERVICE terminal of this Player.
•
Check if the BD disc supports BD-LIVE.
•
Check the setting for "BD Internet Access". (Page 40)
•
Some TVs with wireless remote control capability may operate incorrectly when
using the remote control of this Player. Use such TVs away from this Player.
•
When using this Player, the console cabinet may heat up depending on the usage
environment. This is not a malfunction.
When the AC cord is removed from the outlet, the B (Standby/On) indicator will
•
remain lit for a short period. This is normal and is not a malfunction.
Possible causes and solutions
Possible causes and solutions
" appears on the front panel display when
Advertisement
Table of Contents
Troubleshooting
