About This Guide - Vocera Smartphone User Manual

About this Guide

This guide describes how to use Vocera smartphones to communicate.
It starts with the basics, such as the different features of the device and
how to place and receive calls. It also provides information about sending
messages, broadcasting, setting properties to customize behavior, cleaning and
maintenance, and using the full set of voice commands.
Important: The Vocera smartphone was introduced with the release of Vocera
4.1 SP4. Consequently, all voice commands and features mentioned in this
guide are supported in Vocera 4.1 SP4 or later unless otherwise indicated.
2. Press and hold the Power/End
phone. Wait until the phone screen reads Logged Out or shows someone's
name.
3. Make sure the battery on the phone is fully charged.
New batteries must be charged before use. If the phone has already been
used by someone else, check the battery strength indicator on the phone
screen to make sure the battery has sufficient power.
See Maintaining Your Smartphone
how to charge the battery.
4. Log in: Press the Call button, and hold the phone to your ear. Wait for the
Genie to answer.
• If the Genie asks for your name, say your first and last names.
• If the Genie answers by saying "Vocera" or by playing a tone, say
"Log me in as your first and last name" (for example, "Log me in as John
Smith").
5. Record your name: Press the Call button, wait for the Genie to answer, and
then say "Record my name."
The Genie will prompt you to record your name. If you do not record your
name, the Vocera system uses speech synthesis to say your name.
6. Change the ring tones, if necessary. See
key for one to two seconds to turn on the
on page 119 for instructions on
Sound on page 42.
Welcome to Vocera ··· 11
About this Guide