Cub Cadet TANK LZ 48 Operator's Manual page 8

12. Grass catcher components and the discharge cover are
subject to wear and damage which could expose moving
parts or allow objects to be thrown. For safety protection,
frequently check components and replace immediately
with original equipment manufacturer's (O.E.M.) parts only,
listed in this manual. "Use of parts which do not meet the
original equipment specifications may lead to improper
performance and compromise safety!"
13. Do not change the engine governor settings or over-speed
the engine. The governor controls the maximum safe
operating speed of the engine.
14. Maintain or replace safety and instruction labels, as necessary.
15. Observe proper disposal laws and regulations for gas, oil,
etc. to protect the environment.
WARNING!
follow the warnings and instructions in this manual and on the machine.
8 S 2 — i
ection mportant
Your Responsibility—Restrict the use of this power machine to persons who read, understand and
SAVE THESE INSTRUCTIONS!
S o p
afe peration racticeS
Do not modify engine
To avoid serious injury or death, do not modify engine in any
way. Tampering with the governor setting can lead to a runaway
engine and cause it to operate at unsafe speeds. Never tamper
with factory setting of engine governor.
Notice Regarding Emissions
This machine is equipped with an engine that is certified to
federal EPA emission standards for non-road engines and
equipment, and where applicable to California Air Resources
Board (CARB) emission standards. The engine owner's manual is
supplied by the engine manufacturer, and provides additional
information relating to the emission system, warranty,
maintenance of the engine in accordance with EPA and/or
CARB regulations. Making any unauthorized alterations or
modifications to the engine, fuel, or venting systems may violate
EPA and CARB regulations.
When required, models are equipped with low permeation fuel
lines and fuel tanks for evaporative emission control. California
models may also include a carbon canister. Please contact
Customer Support for information regarding the evaporative
emission control configuration for your model.
This machine is designed to run on regular, unleaded gasoline,
87 octane or higher. Never use gasoline containing methanol or
gasoline containing more than 10% ethanol (i.e., E15 or E85 fuels)
because the fuel system may be damaged.