The Receiver - Silvercrest SL 35 Operating Manual

The receiver

Caution!
Check that connections of all equipment and the
antenna are proper before connecting the receiver to
the mains.
Insert the mains plugs of the connected equipment in
the mains socket and switch it on.
Switch on the AV channel of the TV set. If the TV set
recognizes the switching voltage emitted by the
receiver, it will switch automatically to the AV mode.
Insert the mains plug of the receiver in the mains
socket. Turn on the mains switch on the rear side of
the receiver. The device is in normal mode. The green
LED is lit.
The receiver is supplied with preset TV channels and can
be used directly. If you want to check if new channels are
available, initiate a scan for broadcasting stations. Read
the information further below for this purpose.
To get into standby mode, press the red key at
top right of the remote control. The red LED of
the receiver is lit. The device consumes approx.
2W only. Currently, this is a very low value of
power consumption.
33