Charge
Charging with the self-cleaning recharger
Thoroughly wipe off any drops of water on or around the self-
cleaning recharger so that it is dry before charging the shaver.
1
1
Insert the appliance plug
into the self-cleaning
recharger.
2
2
Remove the protective
cap and then attach the
shaver.
3
3
Plug in the AC adaptor.
•
The "Charge" course starts when attaching the shaver.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
•
You can charge even with the STATUS lamp of the self-cleaning
recharger blinking.
•
Charging is completed after approx. 1 hour.
You can keep the shaver attached to the self-cleaning recharger,
or connected to the AC adaptor, when not using it to maintain full
battery capacity. You cannot overcharge the shaver.
Charging without the self-cleaning recharger
You can also charge without the self-cleaning
recharger.
1. Insert the appliance plug into the shaver.
2. Plug in the AC adaptor into a household
mains socket.
2
You cannot operate the shaver while charging.
3
Reading lamps when charging
1
The charge status lamp (
The number of the battery
capacity lamp will increase as
charging progresses.
•
After charging is completed, turning the power switch ON with
the shaver plugged in will cause all the battery capacity lamps to
light up and then turn off after 5 seconds. This shows that the
shaver is fully charged.
•
Recommended ambient temperature for charging is 5-35 °C. The
battery may not charge properly or at all under extreme low or
high temperatures. The charge status lamp (
there is a problem with charging.
•
When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charge status lamp (
may not glow. It will eventually glow if kept connected.
While charging
After charging is completed
) glows.
All the battery capacity lamps
will light up and then turn off
after 5 seconds.
2
1
) will blink when
)
5