Indoor Unit - Panasonic CS-E12GFEW Operating Instructions Manual

INDOOR UNIT

CAUTION
CLEANING INSTRUCTIONS CLEANING INSTRUCTIONS
• Do not use benzene, thinner or scouring powder.
• Use only soap ( pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
1
INDOOR UNIT
• Wipe the unit gently with a soft, dry cloth.
2
INTAKE GRILLE
1. Release 2 levers to open.
2. Release string to remove. Wash gentle and dry.
3
REMOTE CONTROL RECEIVER
4
ALUMINIUM FIN
5
HORIZONTAL AIRFLOW DIRECTION LOUVER
• Both upper and lower louvers are manually
adjustable.
6
VERTICAL AIRFLOW DIRECTION LOUVER
• Do not adjust by hand.
7
AUTO OFF/ON BUTTON
• Use when remote control is misplaced or a malfunction
occurs.
Press once.
Press and hold until 1 beep is heard, then release. Cooling
Press and hold until 1 beep is heard, then release.
Press again until 2 beeps, then release.
Press the button to turn off.
6
• Switch off the power supply before cleaning.
• Do not touch the aluminium fi n, sharp parts may cause injury.
6
Remove Remove
8
2
1. Release 1. Release
Action
HINT HINT
• Clean the fi lter regularly for best performance and to
reduce power consumption.
• Please consult your nearest dealer for seasonal
inspection.
5
4
Remove Remove
1. Release 1. Release
8
AIR FILTERS
• Clean the fi lters regularly.
• Wash/rinse the fi lters gently with water to avoid damage to
the fi lter surface.
• Dry the fi lters thoroughly under the shade, away from fi re or
direct sunlight.
9
AIR OUTLET SELECTION SWITCH
To select preferred airfl ow pattern.
Selection Pattern
This setting automatically decides airfl ow pattern
depending on mode and conditions (Default and
recommended).
Mode
Auto
Heating
7
3
9
1
2. Release 2. Release
5
Description
This setting blows air from upper outlet
only.
For Heat mode, during start or low
discharge temperature / For Cool mode,
when setting temperature is achieved,
the air is blown from the upper air outlet
only.
Air is blown from the upper and lower
air outlets for high speed cooling during
COOL mode, and for fi lling the room with
warm air during HEAT mode.