JETWAY 865GDA User Manual page 18

(4) IDE Activity LED: IDE LED
This connector connects to the hard disk activity indicator light on the case.
(5) Reset switch lead: RESET
This 2-pin connector connects to the case-mounted reset switch for rebooting your computer
without having to turn off your power switch. This is a preferred method of rebooting in order
to prolong the lift of the system's power supply. See the figure below.
(6) Speaker connector: SPEAK
This 4-pin connector connects to the case-mounted speaker. See the figure below.
(7) Power LED: PWR-LED
The Power LED is light on while the system power is on. Connect the Power LED
from the system case to this pin.
(8) Power switch: PWR BTN
This 2-pin connector connects to the case-mounted power switch to power ON/OFF the
system.
(9) Wake On-LAN Headers (3-pin) : WOL
This connector connects to a LAN card with a WAKE ON-LAN output.
connector power up the system when a wake up signal is received through the LAN
card.
NOTE: This feature requires that Wake On LAN or Ring In Wake up is enabled.
C O M _ 2
Note: Orient the read marking on the
Pin 1
Serial Port2 COM2 Header
SPEAK JW_FP
Pin 1
Pin 1
System Case Connections
15
COM2 ribbon cable to pin 1
This