Operation; Care And Cleaning - Sharp SJ-30V Operation Manual

OPERATION

Controlling temperatures
• FREEZER TEMP. CONTROL regulates the quantity of
cold air to the freezer.
• If the freezer does not cool even when setting FREEZER
TEMP. CONTROL to MAX, set REFRIGERATOR TEMP.
CONTROL to MAX as well.
• With FREEZER TEMP. CONTROL set to MAX, there will
be less cold air directed to the refrigerator compartment,
and the refrigerator compartment may not become cold
enough.
• REFRIGERATOR TEMP. CONTROL controls the
compressor running time of the refrigeration system.
• MAX setting will result in colder temperature in the both
(refrigerator and freezer) compartments.
• The freezer compartment may not cool sufficiently when
leaving REFRIGERATOR TEMP. CONTROL as MIN for an
extensive period. To cool the freezer compartment properly,
set REFRIGERATOR TEMP. CONTROL closer to MAX.
Over 35°C ambient temperature

CARE AND CLEANING

WARNING
Unplug the refrigerator first to prevent electric
shock.
Do not splash water directly on the outer cabinet
or the interior. This may lead to rusting and
deterioration of the electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips.
• Wipe any food oils adhered to plastic components.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
1. Remove the shelves and pockets from the cabinet and
door. Wash them in warm soapy dishwashing water;
rinse in clean water and dry.
2. Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
4
This is because MAX setting (FREEZER TEMP.
CONTROL) may result in too little air flow to the
refrigerator compartment, causing too warm temperature
in the refrigerator compartment.
Under 10°C ambient temperature
This is because the com-
pressor operation is too
short in winter, and not
enough cold air is provided
to the freezer compartment.
Hints when making ice
1. Pour the water into the ice cube tray
to the water level line.
2. After the ice cubes are made, hold the
ice cube tray upside down and twist
the tray to remove the ice cubes.
NOTE :
To prevent damage to the Ice cube
box, do not make ice in the Ice cube
box or pour oil into it.
Deodorizing unit
Deodorizing catalyst is installed on the routes of cold air.
No operation and cleaning are required.
Defrosting
Defrosting is fully automatic due to a unique energy saving
system.
3. Wipe the exterior with a soft cloth each time it is soiled.
4. Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
NOTE
To prevent damage to your refrigerator, do not use heavy
•
duty cleansers or solvents (lacquer, paint, polishing powder,
benzine, boiled water, etc.).
If the power supply is disconnected, please wait for at least
•
5 minutes before re-connecting power.
Do not drop objects inside the refrigerator or strike the inner
•
wall. This may cause the inner surface to crack.
When the compartment light is blown
Contact SHARP Service Center to request a replacement
of compartment light. The compartment light should not
be removed other than by qualified service personnel.
Switching off your refrigerator
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power
socket and leave all doors open.
If the foods in the refrig-
erator compartment
freeze.
Ice cube tray