Changing Blades - DeWalt SS200 Instruction Manual

WRENCH AND BLADE
STORAGE
A convenient wrench and blade holder (A) Fig. 13, is
supplied on the left side of the rear casting, which allows
you to store the hex wrenches (C), quickset blade
changing wrench (B) and extra scroll saw blades when
not in use.

CHANGING BLADES

1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Remove table insert.
3. Position blade tension lever (A) Fig. 19, in the vertical
position to release blade tension.
4. Insert long end (A) Fig. 14, of quickset blade
changing wrench into hole (B) in upper blade holder. This
will align wrench (C) with blade holder screw (D).
5. Fig. 15, illustrates the quickset blade changing
wrench (E) engaged with the upper blade holder
assembly. Turn wrench counterclockwise to loosen
screw (D) and remove blade (F) from upper blade holder
as shown.
B
B
D
D
F
8
C
A
Fig. 13
A
C
Fig. 14
Fig. 15
E