Related Manuals for Kuppersbusch IG 633.1
Summary of Contents for Kuppersbusch IG 633.1
- Page 1 BEDIENUNGSANLEITUNG (Teil 2) Notice d’utilisation (partie 2) page 8 Gebruiksaanwijzing (deel 2) bladzijde 15 Instruction book (part 2) page 21 IG 633.1...
-
Page 2: Description Of The Appliance
Description of the appliance Upper basket stop Water hardness switch Salt container Detergent dispenser (type A / type B) Control panel Rating plate Rinse aid dispenser (type A / type B) Filters Lower spray arm 10. Upper spray arm 11. Upper basket IN143 The control panel Programme sequence indicator... -
Page 3: In Daily Use
In daily use Check if it’s necessary to refill with special salt or rinse aid When loading the dishes and cutlery, please note: - Dishes and cutlery must not impede the rotation of the Load cutlery and dishes into the dishwasher. spray arms . -
Page 4: The Upper Basket
The upper basket Adjusting the height of the upper basket The upper basket is designed for plates (dessert plates, If washing very large plates you can load them in the lower saucers, dinner plates of up to 25 cm in diameter), salad basket after moving the upper basket to the higher position. -
Page 5: Starting A Washing Programme
Starting a washing programme 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Turn on the water tap 3. Close the dishwasher door 4. Setting and starting the programme Turn the programme selector dial clockwise until the number of the programme you wish to select corresponds with the programme marker on the control panel (see "Washing programmes"... -
Page 6: Security System
Building-in Security system This dishwasher is designed to be fitted under a kitchen Inlet hose counter or worksurface. Attention! inlet hose has a high pressure resistance. Carefully follow the instructions on the enclosed template for building in the dishwasher and fitting the furniture panel. It can sustain pressures up to 6000 kPa (60 bar), 6 times a normal hose. -
Page 7: Hints For Test Centres
Hints for test centres Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing programmes" chart). Test in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see "Washing programmes"...
Need help?
Do you have a question about the IG 633.1 and is the answer not in the manual?
Questions and answers