Subscribe to Our Youtube Channel
Related Manuals for Küppersbusch IGV 458.4
Summary of Contents for Küppersbusch IGV 458.4
- Page 1 LIBRETTO ISTRUZIONI Manual de instrucciones página 18 Instruction book page 34 IGV 458.4...
-
Page 2: Table Of Contents
Contents Safety instructions Installation instructions Building-in Disposal Levelling Fixing to adjacent units Economical and ecological dishwashing Water supply connections Description of the appliance Water outlet hose connection Electrical connection The control panel Hints for test centres Prior to using for the first time Setting the water softener Filling with salt Rinse aid... -
Page 3: Safety Instructions
Safety instructions It is most important that this instruction book should be Under no circumstances should you attempt to repair the retained with the appliance for future reference. Should machine yourself. Repairs carried out by inexperienced the appliance be sold or transferred to another owner, or persons may cause injury or serious malfunctioning. -
Page 4: Description Of The Appliance
Description of the appliance Upper basket stop Upper spray arm Salt container Detergent dispenser Control panel Rinse aid dispenser Filters Lower spray arm Upper basket IN97 The control panel Audible signals To deactivate these audible signals, press simultaneously "2" and "3" programme push buttons, after about 3 seconds an Audible signals have been introduced to help indicate which audible signal informs you that the audible signals have been operations the dishwasher is performing. -
Page 5: Prior To Using For The First Time
Prior to using for the first time Before using your dishwasher for the first time: To set a different level, proceed as follows: 1. Ensure that the electrical and water connections comply 1. Press simultaneously programme push buttons "2" and "4" with the installation instructions for about 5 seconds. -
Page 6: Filling With Salt
Filling with salt Rinse aid Rinse aid is automatically added during the last rinse, ensuring Special salt can be added in one of two ways: thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 If you are using dishwasher detergent that already contains ml of rinse aid, which is sufficient for 16 - 40 dishwashing salt, the detergent including the salt is placed in the... -
Page 7: In Daily Use
Clean up any rinse aid spilt during filling with an Adjusting the dose absorbent cloth to avoid excess foaming during the next According to the finish and drying results obtained, adjust the wash. dose of rinse aid by means of Only use branded rinse aid for dishwashers. -
Page 8: The Lower Basket
Open the door and slide out the baskets to load the dishes. The upper basket The upper basket is designed for plates (dessert plates, The lower basket saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. The lower basket is designed to take saucepans, lids, plates, Arrange items on and underneath the cup racks so that water salad bowls, cutlery etc. -
Page 9: Use Of Detergent
Use of detergent Detergent tablets Only use detergents specifically designed for use in Detergent tablets of different brands dissolve at different dishwashers. speeds. For this reason some detergent tablets cannot develop their full cleaning power during short programmes. Using no more then the correct amount of detergent Therefore please use normal programmes with prewash when contributes to reducing pollution. -
Page 10: Washing Programmes
Washing programmes (3) Consumption values Programme Degree of soil Programme Cycle push description Energy Water Programme type of load button duration consumption consumption (in kWh) (in litres) (in minutes) Any. Partial load (to Rinse and Hold 1 cold rinse (to avoid food avoid food scraps 0,02 scraps from sticking together) -
Page 11: Starting A Washing Programme
Starting a washing programme In this fully integrated appliance the controls are located on the 6. End of the washing programme top of the door. When selecting a programme, the door needs The dishwasher will automatically stop and an audible to be open. -
Page 12: Maintenance And Cleaning
Maintenance and cleaning Clean the external surfaces of the machine and control panel To ensure a correct with a damp soft cloth. If necessary use only neutral working of the dishwasher, detergents. Never use abrasive products, scouring pads or NEVER try to remove the solvent (acetone, trichloroethylene etc..). -
Page 13: What To Do, When
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer..a flashing fault code appears The dishwasher does not start or stops during operation. An intermittent audible signal informs you that an alarm is activated. All push buttons are inoperative except for the On/Off push button. -
Page 14: Service And Spare Parts
...the wash results are not satisfactory The dishes are not clean The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load. -
Page 15: Installation Instructions
Installation instructions Any electrical and/or plumbing work required to install Water supply connections this appliance should be carried out by a qualified This dishwasher may be fed with either hot (max. 50°) or cold electrician and/or plumber or competent person. water. -
Page 16: Water Outlet Hose Connection
Water outlet hose connection Electrical connection The end of the drain hose can be connected in the following Information concerning the electrical connection is given on the ways: rating plate on the edge of the dishwasher’s door on the right. 1. -
Page 17: Hints For Test Centres
Hints for test centres Testing in accordance with EN 60704 must be carried out with appliance fully loaded and using the test programme (see "Washing programmes" chart). Test in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see "Washing programmes"...
Need help?
Do you have a question about the IGV 458.4 and is the answer not in the manual?
Questions and answers