Table of Contents
Advertisement
MCS-100
Passive Mode
Active Mode (4.5)
Shock Sensor Disable
Shock Sensor Enable (4.6)
Valet Mode On
Valet Mode Off (4.7)
Audible Warning Sound Off
Audible Warning Sound On (4.8)
Siren Output Tone Selection (4.9)
Shock Sensitivity Level Selection
(4.10)
4.1 Permanent Reprogrammable Factory Code (Code Pre-Programmed By Factory)
When the Dealer installs the unit he programs your unique code which is in permanent memory. Any Authorized Dealer
can add a new or an additional pre-coded transmitter and delete an existing code from memory.
To program a new code:
Turn the ignition key on and off five (5) times.
CODE CHANGE MODE is confirmed with one chirp sound and one parking light flash
Within 3 seconds, PRESS BUTTON #1. One chirp and one parking light flash will confirm the acceptance of
new code. This operation will erase all previous codes.
Within 3 seconds, PRESS BUTTON #1 of 2
the acceptance of second code.
Within 3 seconds, PRESS BUTTON #1 of 3
the acceptance of third code.
Code program will exit when 3 seconds is passed, when ignition is turned off or when all three codes are
programmed.
Note: Module will accept three different transmitters.
4.2 Permanent Siren Chirp Enable/Disable (Factory default setting: Siren Chirp Enable)
Siren chirp can be permanently enabled and disabled from your remote transmitter.
For PERMANENT SIREN CHIRP DISABLE:
Turn the ignition key to the on position.
Within ten (10) seconds, PRESS BUTTON #2 for a five (5) seconds.
Siren chirp disable is confirmed with one parking light flash.
For PERMANENT SIREN CHIRP ENABLE:
Turn the ignition key to the on position.
Within ten (10) seconds, PRESS BUTTON #2 for a five (5) seconds.
Siren chirp enable is confirmed with two chirp sounds and two parking light flashes.
Version A
Turn Ignition on. Press button #3 (#3 = #1 + #2) for 5
seconds.
Turn ignition on. Within 10 seconds, press button #1, #2,
#3, #1 in succession. (#3=#1+#2)
Turn Ignition on. Within 10 seconds, press button #2, #3,
#2, #3 in succession. (#3=#1+#2)
Turn Ignition on. Within 10 seconds, press button #1, #3,
#2, #1 in succession. (#3=#1+ #2)
Turn Ignition on. Within 10 seconds, press button #1, #2,
#1, #2 in succession. (#3=#1+#2)
Turn Ignition on. Within 10 seconds, press button #1, #3,
#1, #3 in succession. (#3=#1+#2)
nd
transmitter. One chirp and one parking light flash will confirm
rd
transmitter. Once chirp and one parking light flash will confirm
4
1
1
2
2
1
1
2
2
1
1
2
2
1
1
2
2
1
1
Advertisement
Table of Contents
