Advertisement
Security Systemsystems
Product
Document type
DVR 400 Series
Release notes
4. Time line in search menu can be zoomed three times in this release.
Was only one time.
5. PTZ function of movable cameras is slow using control via a Web Client. In this release
customer can select the P/T speed in three pre-defined steps using the Web interface.
6. Playback icon added in cameo to clearly identify the difference between live and playback
pictures.
In PTZ control panel on local unit and Web interface the text on Aux button changed for OFF
and ON to Aux- and Aux+
This release includes the following bug fixes:
1. After a power cycle video is deleted for max. 1 hour in the following conditions:
-
Daylight saving is set to ON
-
Daylight saving is activated (Summer time)
2. The detection of Video format (PAL or NTSC) has been improved.
3. Sometimes the DDNS update of the DVR 400 failed (updated WAN IP providers)
3.5
Version 1.3.0
File name: 400series.bin (2010-05-31)
This release includes the following improvements:
1. Fixed missing stop command in Dome control via RS232 using front panel buttons or IR
Remote Controller.
2. In this release the IR Remote Controller can have ID range 1 to 9 to control up to nine
different DVR's with one remote control.
3.6
Version 1.2.0
File name: 400series.bin (2010-04-29)
This release includes the following bug fixes:
1. Continual restart of the unit:
After a power cycle, the Hard Disk Drive in the unit must be recovered. This could take
some time, depending on the number of recording blocks. A lot of small recording blocks
will be created especially in applications where the recording settings for the four channels
are set to Normal-Event-Normal-Event recording and the events will be triggered very often.
After the recorded video has been overwritten many times and the unit is power cycled, the
HDD recovery time could exceed the watch dog time of 1 minute. This results in the unit
continuously restarting. If this is happening then the unit must be sent in for repair.
This can be prevented by upgrading the unit beforehand to firmware version 1.2 or higher
where this issue is solved.
Therefore, we strongly recommend upgrading all units from v1.1.0 to v1.2.0 or higher.
2. Option to enable NTP via the configuration screen on the web pages.
3. The setting of network "Bandwidth limit" being limited to 100, 10, 5, 2, 1 Mbps, and
512 Kbps.
4. Playback of 4 channels (quad mode) on the web pages is improved.
Release #
SAP/Doc number
V2.1.1
Release date
2013.11.08
Page 5 of 6
Advertisement
