Baby Lock BND9-2 Instructions

Software update version 4.21

Hide thumbs Also See for BND9-2:

Download this manual

December, 2013

Introduction

If the software version of your BND9-2 is earlier than Version 4.21, an update program is now

available for download to improve its performance.

Version 4.21 update will provide the following changes:

1. Fixed the situation where the LED pointer was not turned on when moving the needle back using

the Forward/Backward Stitch Key after the error message for checking the upper or bobbin thread

was displayed

2. Fixed the situation where the machine may not work correctly after the error message was

displayed by selecting the appliqué setting.

3. Improved so that the embroidery pattern moves by 0.1 mm when the arrow keys are pressed on the

pattern editing screen.

When you press and hold the arrow keys, the pattern moves by 5 mm.

To confirm the software version of your BND9-2

1. Press the power switch to turn on your machine. The LCD screen comes on.

2. Touch anywhere on the initial screen and then touch "OK".

3. Touch

4. Switch screens by using

software version.

Baby Lock Endurance 2

(Model BND9-2)

Software Update Version 4.21

(Settings key) at the bottom of the LCD display. The Settings screen appears.

(Previous page key) or

Customer Support: 1-800-313-4110

BND9-2 Ver. 4.21 Software Update – p.1

(Next page key) to display the

Page 1 Software Update Version 4.21 December, 2013 Introduction If the software version of your BND9-2 is earlier than Version 4.21, an update program is now available for download to improve its performance. Version 4.21 update will provide the following changes: 1. Fixed the situation where the LED pointer was not turned on when moving the needle back using...
Page 2 BND9-2 Ver. 4.21 Software Update – p.2 Note: The number of pages in the Settings screen will vary depending on the program version in your machine. 5. If the version shown on your machine is already Version 4.21 or later, it is not necessary to update your machine with the program on this page.
Page 3 BND9-2 Ver. 4.21 Software Update – p.3 Baby Lock Endurance 2 (Model BND9-2) Update History  Version 4.20 update provided the following changes. 1. Fixed the situation where the embroidery pattern was not rotated 180 degrees if the embroidery frame was changed from a cap frame to a different type of frame or from a different type of frame to a cap frame when the machine finished sewing the pattern using the Link function.

Endurance 2