Baby Lock BND9-2 Instructions

December, 2013

Introduction

If the software version of your BND9-2 is earlier than Version 4.21, an update program is now
available for download to improve its performance.
Version 4.21 update will provide the following changes:
1. Fixed the situation where the LED pointer was not turned on when moving the needle back using
the Forward/Backward Stitch Key after the error message for checking the upper or bobbin thread
was displayed
2. Fixed the situation where the machine may not work correctly after the error message was
displayed by selecting the appliqué setting.
3. Improved so that the embroidery pattern moves by 0.1 mm when the arrow keys are pressed on the
pattern editing screen.
When you press and hold the arrow keys, the pattern moves by 5 mm.

To confirm the software version of your BND9-2

1. Press the power switch to turn on your machine. The LCD screen comes on.
2. Touch anywhere on the initial screen and then touch "OK".
3. Touch
4. Switch screens by using
software version.
Baby Lock Endurance 2
(Model BND9-2)
Software Update Version 4.21
(Settings key) at the bottom of the LCD display. The Settings screen appears.
(Previous page key) or
Copyright  2004-2013 Baby Lock USA
Customer Support: 1-800-313-4110
BND9-2 Ver. 4.21 Software Update – p.1
(Next page key) to display the