Zanussi ZDC67560W User Manual page 11

1 2
Selecting additional functions
You can choose from the additional functions:
button 1 - DELICATE
button 2 - ANT-ICREASE
button 3 - BUZZER
button 4 - DELAY
DELICATE
gentle drying with reduced heat of sensitive fabrics
and temperature-sensitive textiles (e.g. acrylic, vis-
cose) marked on care label with:
ANTI-CREASE
prolongs the anti-crease phase to 90 mins in total.
The laundry remains relaxed and free of creases.
BUZZER
audible confirmation of:
• cycle end
• anti-crease phase start and end
• cycle interruption
• error
DELAY START
allows to delay the start of a drying programme: 3
or 6 or 9 hours
1. select the drying programme and additional
drying options
2. press the Delay button repeatedly until the de-
sired delay start is chosen
3. to activate the delay timer, press the Start/
Pause button
Starting the programme
Press Start/Pause button to start the dryer af-
ter having selected the programme and the op-
tions. The relevant light will stop flashing. If the
programme selector dial is turned to another
position, when the machine is running, the buz-
www.zanussi.com
4
3
zer will sound and the programme phase indica-
tor lights will flash. The drum turns alternately in
both directions during drying.
All drying programmes end with a 10 minute
cooling phase. You may remove the laundry af-
ter this phase.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the pro-
gramme from the point at which it was interrup-
ted. This button must be depressed also after a
power failure and after having reinserted the
water reservoir, if it has been emptied in the
middle of a programme after lighting up of light
Tank .
In both cases the light of the Start/Pause but-
ton flashes to remind you that the start button
needs to be pressed again.
Indicator lights
These lights indicate the following functions:
• Drying light: This light indicates that the ap-
pliance is in the drying phase.
• End/Anti-crease light: This light is on at the
end of the cooling phase, during the anti-
creasing phase and at the end of the pro-
gramme.
• Tank light: This light indicates that the appli-
ance is in the drying phase. This light comes
on at the end of the programme to remind
you that the water reservoir must be emptied
out. If this light illuminates during a pro-
gramme this means that the water reservoir is
full. The buzzer sounds, the programme
stops, the light of the Start/Pause (Start/
Pause) button flashes. This light comes on al-
so when the water reservoir is not inserted
correctly.
• Filter light: This light illuminates at the end of
the programme to remind you that the filters
must be cleaned.
• Condenser light: It comes on every 80 cy-
cles to remind you that the condenser must
be cleaned.
Changing programme
To change a programme which has been selec-
ted by mistake once the programme has started,
11