Installing The Scanner; Connecting The Cables - Fujitsu fi-6110 Getting Started Manual

Installing the Scanner

The following describes how to install the scanner.
1.
Place the scanner at its installation site.
292
493.5
(11.50)
(19.43)
Carry the scanner by supporting it
from the bottom.
2.
Attach the ADF paper chute.
Insert the tabs on the ADF paper chute into
the slots on the back of the scanner, and
push in to lock it firmly.
Tab
380
(14.96)
130 (5.12)
143
(5.63)
850
(33.46)
Unit: mm (in.)
Scanner's Dimensions
Installation Space
ADF Paper Chute
Side Guide

Connecting the Cables

The following describes how to connect the cables
between the scanner and your computer.
4
2
Power Connector
USB Connector
USB Cable
CAUTION
Do not use AC adapters other than the one
supplied with this scanner. Doing so may
cause damage to the scanner.
Manufacturer: Sanken Electric Co., Ltd.
Model number: SED80N2-24.0
1.
Make sure that the computer is turned off.
2.
Connect the USB cable with the USB
connector of the scanner and the USB port
of the computer.
Be sure to use the USB cable which
comes as an accessory with this
scanner.
When connecting to an USB hub,
use the first stage USB hub that is
closest to the computer. If you use
the second or later hub stages, the
scanner may not operate correctly.
If you connect the scanner with USB
2.0, it is required that the USB port
and the hub be compliant with USB
2.0. The scanning speed slows down
when you connect the scanner with
USB 1.1.
Connect the USB cable with the side
showing the USB mark facing up.
USB mark should
face up
6
AC Adapter
AC Cable
4
3
2
1