Sony Cyber-shot DSC-S600 Service Manual page 7

• The Repair Board has already been adjusted. Re-initialization or EVR data copy from the set before repair is not required.
• Perform "Initial Language Data Check" mentioned below, and also the adjustment items necessary after SY Board replacement.
If the SY-145 board was replaced, initial language setting may be changed. Accordingly, change the following data so as to set same initial
language as that of the set distributing in each region.
Initial language: Language displayed at the next starting if the setting of Setup menu was reset.
It is different from the language setting selectable with the menu.
Initial Language Data
00
04
06
4F 8C 08
0B
0D
GP2 is fixed to English.
GP3 is either English, Spanish, or Russian.
GP4 is either English, Spanish, Portugal, Simplified Chinese, or Korean.
Writing Method:
1) Select page: 00, address: 01 and set data: 01.
2) Select page: 4F, address: 8C, and set the Initial Language Data.
3) Select page: 40, address: 38, and set data: 00.
Click [Save] on the SEUS screen.
4)
5) Select page: 80, address: 34, and check that the data is "00".
6) Select page: 80, address: 30, and check that the data is "00".
7) Select page: 00, address: 01, and set data: 00.
8) Turn off the camera.
9) Turn on the camera. Execute "Initialize" of Setup screen.
10) Check the language displayed when the camera starts.
Remove the LB-117 board from the cabinet (front) asembly, solder the leads to the SW-461 board, and fix the S101 switch (Lens barrier
open) to the ON position with an adhesive tape.
z
English
Spanish
Portugal
Simplified Chinese
Russian
Korean
z z
z z
z
z
z
z