GE JGSP20GEP Use And Care Manual page 21

Set the Oven for Cleaning
The range must be completely cool
in order to set the self-clean cycle.
1. Push the CLEAN button.
2. Turn SET knob in the clockwise
direction about l/2 turn. The display
will show "3:30?
The words "CLEAN TIME" will
be displayed on the left. Within 20
minutes, the words "CLEAN
LOCK" will be displayed on the
right.
Note: You can find out when the
clean cycle will be finished by
pushing the STOP TIME button.
The word "DOOR" is displayed
when you try to set a clean cycle
with the door open or when the
oven temperature is too high.
To Set a Delayed Start
1. Push STOP TIME button.
2. Turn SET knob to time of day
when you wish cleaning to be
completed (must be more than
3% hours later than current time
of day).
3. Push the CLEAN button.
4. Turn SET knob in the clockwise
direction about 1/2 turn.
The words "DELAY CLEAN" will
be on in the display until the clean
cycle starts. After the clean cycle
starts, the word "CLEAN" will be
on in the display.
Note: During a delayed self-clean
operation, you can find out when
the oven turns on by pushing and
holding the CLEAN button.
To Stop a Clean Cycle
1. Press the CANCEL button.
2. Wait until the oven has cooled
below locking temperature (about
20-30 minutes) and the word
"LOCK" is off in the display.
You will not be able to open the
door right away unless the oven
temperature is at a safe level. If
you cannot open the oven door
immediately after the word
"LOCK" goes off, wait one
minute and try again.
After Self-Cleaning
1. When a clean cycle is finished,
the word "CLEAN" will be off in
the display.
2. Wait until the oven has cooled
below locking temperature (about
20-30 minutes) and the word
"LOCK" is off in the display.
You will not be able to open the
door unless the oven temperature
is at a safe level. If you cannot open
the oven door immediately after the
word "LOCK" goes off, wait about
one minute and try again.
You may notice some white ash
in the oven. Just wipe it up with
a damp cloth.
If white spots remain, remove them
with a soap-filled steel wool pad.
Be sure to rinse thoroughly with a
vinegar and water mixture. These
deposits are usually a salt residue
that cannot be removed by the
clean cycle.
If the oven is not clean after one
clean cycle, repeat the cycle.
(continued nextpage)
21