Range Lockout - GE JGS968 JGSP48 Owner's Manual

Ge appliances gas range owner's manual jgs968 jgsp48
Hide thumbs Also See for JGS968 JGSP48:
Table of Contents

Advertisement

Using the clock, timer and range lockout.
Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
On some models
On some models
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
Touch the KITCHEN TIMER
ON/OFF pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake touch the KITCHEN TIMER
ON/OFF pad and begin again.
Touch the START pad.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by
touching the KITCHEN TIMER ON/OFF pad,
then touch the number pads until the
time you want appears in the display.
To Cancel the Timer
Touch the KITCHEN TIMER ON/OFF
pad twice.

Range Lockout

Your control will allow you to lock out the touch
pads so they cannot be activated when pressed.
To lock/unlock the controls:
Touch the RANGE LOCKOUT pad
until the display shows LOC, then
touch the START pad.
The display will flash "turn surface
burners off" twice and then LOC.
To unlock the control, touch
the RANGE LOCKOUT pad until the
display shows LOC OFF. Then touch
the START pad.
The display will flash "turn surface
burners off" twice and the time of
day will be displayed.
www.GEAppliances.com
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad
is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the KITCHEN TIMER ON/OFF pad
and then touching the number pads to
enter the new time you want.
On some models, touch and hold the 9
and 0 pads at the same time for 3 seconds
until the display shows LOC ON. To unlock
the control press and hold the 9 and 0
pads at the same time until the display
shows LOC OFF.
When this feature is on and the touch
pads are touched, the control will beep
and the display will show LOC ON.
s
The control lockout mode affects all touch
pads. No touch pads will work when this
feature is activated.
s
The adjustment will be retained in memory
after a power failure.
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jgs968

Table of Contents