Advertisement
ASSEMBLY
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you nish all assembly steps.
•• To identify small parts, see the drawings in the
box below. The number in parentheses below
each drawing is the key number of the part, from
the PART LIST near the end of this manual. The
number following the key number is the quantity
needed for assembly. Note: If a part is not in the
hardware kit, check to see if it has been preas-
sembled. Extra parts may be included.
M8 Washer
M8 x 20mm
Screw (9)––4
1. Orient a Base (3) as shown.
Attach the Base (3) to one of the Uprights
(2) with two M10 x 50mm Bolts (7), four M10
Washers (10), and two M10 Locknuts (12).
Attach the other Base (3) to the other Upright
(2) in the same way.
M10 Washer
(11)––4
(10)––12
M10 x 20mm
Bolt (8)––4
•• In addition to the included tool(s), assembly
requires the following tool(s):
one Phillips screwdriver
two adjustable wrenches
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
M10 Locknut
(12)––8
M10 x 50mm Bolt (7)––4
1
2
12
10
3
10
7
4
2
12
10
3
Foot
Advertisement
