Kenmore 148.16156210 Use & Care Manual page 13

1. Make sure that the Main Light switch on the control
panel is pressed to OFF, and that transformer power
cord is disconnected from power source.
2. Use a screwdriver to loosen the screw holding the
lens in place.
While loosening the screw, hold the lens in
place so that it does not fall and break.
Lens
3. Remove the lens.
Screw
Lens
13
4. Pull out the light bulb and replace with a new bulb.
5. Reverse the instruction from "steps" 3-1for
installation.
1. To protect against electric shock, do not immerse
cord or plugs in water or other liquid;
2. Unplug from the outlet when not in use and before
cleaning. Allow to cool before putting on or taking
off parts;
3. Do not operate any outdoor cooking gas appliance
with a damaged cord, plug, or after the appliance
malfunctions or has been damaged in any manner.
Contact the manufacturer for repair;
4. Do not let the cord hang over the edge of a table or
touch hot surfaces;
5. Do not use an outdoor cooking gas appliance for
purposes other than intended;
6. When connecting, first connect plug to the outdoor
cooking gas appliance then plug appliance into the
outlet;
7. Use only a Ground Fault Interrupter (GFI) protected
circuit with this outdoor cooking gas appliance;
8. Never remove the grounding plug or use with an
adapter of 2 prongs;
9. Use only extension cords with a 3 prong grounding
plug, rated for the power of the equipment, and
approved for outdoor use with a W-A marking.
Bulb