To Assemble Bagger; To Install Bagger Support Assembly - Husqvarna CTH 224T Instruction Manual

TO ASSEMBLE BAGGER

• Unfold bag and stand right side up.
• Uninstall carriage bolts (5/16-18 x 1.5) and nuts (1) from the
front of the top frame.
1
• Feed front bagger frame (2) up through fabric loops at each
side of bagger.
• Reinstall carriage bolts and nuts (1) to connect front frame to
top frame, passing through bagger and bagger fabric. Tight-
en securely.
CAUTION: Do not exceed 100 In-Lbs/11,2 Nm.
1
• Snap bottom of front bagger frame (3) into snap feature at
front of bagger bottom.
• Remove cross braces (4) from inside of bagger assembly.
• Slide cross brace (4) onto pin (5) at the rear of the upper
bagger frame and secure with retainer spring clip (6).
• Secure cross brace (4) with clevis pin (7) at the front of the
bagger frame and secure with retainer spring clip (8).
• Repeat on opposite side.
6
7
8
4

TO INSTALL BAGGER SUPPORT ASSEMBLY

• Install carriage bolts (1) and locknuts (2) onto upper clevis
brackets (3) and bagger pivot assembly (4) as shown.
4
2
3
1
2
5
3
2
3
• Remove the mounting bolts (5) from the back of the unit.
Using those same mounting bolts (5), install the bagger
support assemblies (6) onto the back of the unit.
• Tighten bolts (5) to 40,7 Nm.
• Check set screws (7). Tighten as needed.
CAUTION: Do not exceed 100 In-Lbs/11,2 Nm.
5
• Uninstall locknut, washer, and carriage bolt (8) and remove
bagger pivot (9) from bagger support tube (10).
• Repeat these steps for both bagger support assemblies.
8
10
• Slide bagger pivot (9) onto the end of the bagger pivot
assembly (4).
NOTE: The flush edge (11) of the bagger pivot (9) should be
facing inward towards tractor.
• Repeat on opposite side.
• Slide weldment with pivots onto the bagger support tubes
(10) ensuring both bagger pivots (9) are inside bagger
support tubes (10).
• Reinstall carriage bolts, washers, and locknuts (8) as shown.
NOTE: Locknuts should be on inside of bagger support tube (10).
4
9
8
21
6
7
5 6
9
8
11
8
9
10
8
2