Attaching The Front Panel; Resetting The Microprocessor; Switching The Dsp Setting Mode - Pioneer DEH-P88RSII Operation Manual

Before You Start
Release button
3 Put the front panel into the provided
protective case for safe keeping.

Attaching the front panel

1 Make sure the inner cover is closed.
2 Replace the front panel by clipping it
into place.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
% Press RESET with a pen tip or other
pointed instrument.
RESET button
Switching the DSP setting
mode
This unit features two operation modes: the 3-
way network mode (NW) and the standard
mode (STD). You can switch between modes
as desired. Initially, the DSP setting is set to
the standard mode (STD).
! After switching, reset the microprocessor.
WARNING
Do not use the unit in standard mode when a
speaker system for 3-way network mode is con-
nected to this unit. This may cause damage to
the speakers.
% Use a thin standard tip screwdriver to
switch the DSP switch on the side of this
unit.
Section
01
9
En